Rohde & Schwarz R&S TSME6 - Band Options; Licensing

Option concept
R&S
®
TSME6
40User Manual 4900.0033.02 ─ 08
Options Order number Description
R&S TSME6-K51 4900.2488.02 R&S TSME6 scanner option: 5G NR add-on scanning
R&S TSME6-K80 4900.2442.02 pR&S TSME6 scanner option: BTS PE Enabler
4.2 Band options
The R&S TSME6 hardware simultaneously measures in all wireless communications
bands from 350 MHz to 6 GHz. Using band licenses, more cost-efficient configurations
are available for applications where only a limited number of bands need to be mea-
sured simultaneously.
These configurations limit the number of bands that can be measured in parallel. You
can reconfigure the bands for each measurement as desired. Upgrade options are
available to increase the bandwidth of the R&S TSME6 from a limited number of bands
to full bandwidth. The following band options are available:
Table 4-2: Available R&S TSME6 band options
Options Order number Description
R&S TSME6-KAB 4900.2107.02 Measure all bands measured simultaneously
R&S TSME6-K1B 4900.2094.02 Measure 1 band simultaneously
R&S TSME6-K2B 4900.2088.02 Measure 2 bands simultaneously
R&S TSME6-K3B 4900.2071.02 Measure 3 bands simultaneously
R&S TSME6-K4B 4900.2065.02 Measure 4 bands simultaneously
R&S TSME6-K5B 4900.2059.02 Measure bands simultaneously
R&S TSME6-KUB 4900.2307.02 Upgrade: Measure 1 additional band simultaneously
For measurements with R&S TSME30DC/TSME44DC and R&S TSMS53DC down-
converters, the option R&S TSME6-KAB is mandatory.
The R&S TSME6 band assignment can be reconfigured by the user (see Chap-
ter 6.1.4, "Configuring measurement bands - "Band Configuration"", on page 53).
For an overview of available cellular bands and their characteristics see Chapter A,
"Available cellular bands", on page 74.
4.3 Licensing
All options are available with registered or unregistered licenses.
●
Registered licenses (variant .02)
Registered licenses are permanent licenses which are fixed to a serial device num-
ber.
Licensing