Getting started
R&S
®
TSME6
22User Manual 4900.0033.02 ─ 08
Dedicated LAN adapter and IP address for host PC
It is important for the host PC to have its own dedicated LAN adapter for the connec-
tion to one or more R&S TSME6s (or a switch), rather than being integrated in a regu-
lar office network.
If multiple R&S TSME6s are connected to one host PC, the following rules are valid.
●
Using "static IP" or "partial auto-IP" mode, it is important to define unique IP
addresses for each instrument using the R&S TSME Device Manager (see
R&S TSME6 user manual, chapter Configuring the R&S TSME6).
●
Using "full auto-IP" mode, it is recommended to define unique IP addresses for
each instrument, but depending on the software run, it may not be mandatory.
► Connect the supplied LAN cable to the LAN connector on the rear panel of the
R&S TSME6, and to the host PC.
Windows 10 automatically detects the network connection and all devices in the
same subnet when the R&S TSME6 is switched on.
3.1.5.2 Connecting external devices
The SMA connector is sensitive to mechanical stress. Use the following handling pre-
cautions.
●
Always use a torque wrench and mount the cable end with 60 Ncm to 90 Ncm.
●
Do not stack adapters directly at the SMA connector. If you need to use adapters
(e.g: SMA to N), then always use a specific adapter cable (order no.
4900.1700.00).
The following external devices are required for standard operation.
●
Connect the instrument to the power supply as described in Chapter 3.1.4, "Con-
necting to power", on page 15.
●
Connect the PC or notebook LAN port to the LAN port of the R&S TSME6 as
described in Chapter 3.1.5.1, "Setting up the LAN connection to the host PC",
on page 17.
●
Connect the (optional) antenna's SMA connector to the RF IN connector.
NOTE: Do not overload the input power at the RF input connector, otherwise the
input stage could be severely damaged. For maximum allowed values, see the
specifications document.
●
Connect the GPS antenna to the GPS ANT connector of the instrument for time
synchronization to a GPS signal (3 V, max. 25 mA for active antenna). To ensure
time synchronization of the R&S TSME6, it is required to have a GPS antenna con-
nected.
NOTE: A missing GPS antenna will lead over time to the point that signals cannot
be detected anymore. We recommend connecting a GPS antenna at least once
per month.
Preparing for use
To Next Page
Loading...