Configuring the R&S TSME6
R&S
®
TSME6
46User Manual 4900.0033.02 ─ 08
6 Configuring the R&S TSME6
Measurements are performed on the R&S TSME6 via the ROMES, R&S NESTOR or
R&S ViCom interface. Depending on the installed software options, the network is
either scanned for individual standards, or globally over all frequency bands. Details on
scanning networks are described in the ROMES, R&S NESTOR and R&S ViCom man-
uals.
Basic device configuration tasks can be performed directly on the R&S TSME6, via the
host PC, using the "R&S TSME Device Manager".
6.1 Using the R&S TSME device manager
The "R&S TSME Device Manager" is a configuration software tool for scanners of the
R&S TSME and R&S TSMA family. This utility is part of the R&S
®
TSME installation
package. It can also be installed together with ROMES, R&S NESTOR and
R&S ViCom, and is available for download from the Rohde & Schwarz product website
http://www.rohde-schwarz.com/product/TSMx.html.
To start the R&S TSME Device Manager
► To start the R&S TSME Device Manager, double-click the desktop icon or select
the "R&S
®
TsmeTools" program entry in the Windows "Start" menu.
When you start the R&S TSME Device Manager, a dialog box with different tabs is
displayed (see Figure 6-1).
●
Selecting the device
The R&S TSME Device Manager can configure any connected R&S TSME6 that
the software detects in the LAN. The individual devices are identified uniquely by
their serial number. By selecting one of the "Available Devices" by its serial number
in the R&S TSME Device Manager dialog box, you determine which R&S TSME6
the current configuration applies to.
●
Updating the device selection list
If additional R&S TSME6s become available after the R&S TSME Device Manager
has started, you must select the "Refresh Device List" button so the new devices
are included in the "Available Devices" list.
●
Updating the displayed device data
If the current configuration or device information has changed and is not yet dis-
played correctly in the R&S TSME Device Manager, select the "Refresh Device
Data" button to update the display.
If a connection to a R&S TSME6 is not possible (for example due to mismatch of sub-
netmask configuration), only limited information is displayed. For example, no informa-
tion about installed options is available in this case.
Using the R&S TSME device manager
To Next Page
Loading...