Rohde & Schwarz R&S TSME6 - Connecting Multiple R&S Tsme6 S to One Host PC

Getting started
R&S
®
TSME6
24User Manual 4900.0033.02 ─ 08
Figure 3-7: Orientation of the R&S TSME6
2. Power on the R&S TSME6 device.
3. Activate "Dead Reckoning" in the used software (see ROMES, R&S NESTOR or
R&S ViCom documentation).
4. Wait until the used software reports a "3D fix" (time vary depending on the config-
ured GNSS).
5. To calibrate the instrument, perform the following driving procedures in a safe envi-
ronment.
a) 720 degrees right turn.
b) 720 degrees left turn.
c) Drive a straight line with a velocity exceeding 40 km/h.
Note: Whenever the device is switched off, the calibration procedure must be
repeated for the next usage of dead reckoning.
After finishing the calibration, the used software reports a fix state "GPS+DR" or "3D
+DR", in case satellite reception is lost the fix state changes to "DR only".
If using "DR only", the accuracy of the reported position will decrease over time, if it
falls below a certain threshold the receiver will report the state "No Fix".
3.1.6 Connecting multiple R&S TSME6s to one host PC
Due to the compatibility of R&S TSME and R&S TSME6, the combined usage of
R&S TSME and R&S TSME6 devices in an LTE-MIMO setup is possible.
Using multiple R&S TSME6 devices requires sufficient capacity of the used network
link.
A single R&S TSME6 can fully utilize a Gigabit Ethernet connection. If the network link
reaches its maximum capacity, the measurement system decreases the network
Preparing for use