Getting started
R&S
®
TSME6
31User Manual 4900.0033.02 ─ 08
3.1.7 Connecting R&S TSME6 with R&S TSMA6/6B-BP
To power R&S TSMEx devices (scanner, downconverter), the following accessory
cables are necessary.
●
R&S TSMA6-BPPT (single R&S TSMETSMEx power cable, order
no. 4900.1730.02)
●
R&S TSMA6-BP2T (dual R&S TSMETSMEx power cable, order no. 4901.0566.02)
3.1.8 Switching on or off R&S TSME6
To switch on the device
1. Use the supplied power cable to connect the power supply to the instrument.
2. After you have connected the power cable, the R&S TSME6 is powered on.
After booting, the instrument switches to the idle mode and is ready to be accessed by
an application.
To shut down the device
When you press the On/Off key on the rear panel of the R&S TSME6 to switch it off,
the instrument changes to standby mode. In standby mode, the program execution on
the instrument is stopped immediately, but the instrument is still under power connec-
tion.
Do not switch off the instrument while a connection to the application is being estab-
lished, otherwise the application does not close properly. As a result, the software
could crash and must be shut down from the Windows Task manager.
Removing the power supply
If you remove the power supply and reconnect it later, the instrument automatically
boots when power returns.
3.1.9 Connecting the R&S TSME6 to a software application for the first
time
The following procedure describes the steps performed when you connect the
R&S TSME6 to a software application (ROMES, R&S NESTOR, or R&S ViCom) for the
first time. Note that this process takes a few minutes initially.
1. Switch on the R&S TSME6 and the host PC.
2. Start the ROMES / R&S NESTOR / R&S ViCom application on the host PC.
The application searches for R&S TSME6s connected to the host PC.
Preparing for use
To Next Page
Loading...