Configuring the R&S TSME6
R&S
®
TSME6
49User Manual 4900.0033.02 ─ 08
Table 6-1: R&S
TSME6 device information
Label Description
Device
The device can be a receiver R&S TSME6 or a downconverter, e.g. R&S TSME30DC/TSME44DC or
R&S TSMS53DC.
For the R&S TSME30DC/TSME44DC and R&S TSMS53DC, only a reduced set of data is displayed.
"Device Type" Type of device (TSME family, TSMA family)
"Material Number" Order number of the device
"Variant Number" Precise device type (variant)
"Serial Number" Unique ID of the device
"Product Change Index" Version of the device
"MAC Address" Network address of the device
FPGA
"Available FPGA Bit File Ver-
sions"
Previous firmware version backups stored on the device (see also Chap-
ter 6.1.5, "Obtaining firmware and correction data updates - "Updates"",
on page 55 )
"Current FPGA Bit File Ver-
sion"
Currently used firmware version
"Power Board"
"Serial Number" Unique ID of the power board
"Product Change Index" Version of the power board
"Controller Board"
"Serial Number" Unique ID of the controller board
"Product Change Index" Version of the controller board
"Temperature" Current temperature of the hardware in [°]C
"RF Board"
"Serial Number" Unique ID of the RF board
"Product Change Index" Version of the RF board
"Temperature" Current temperature of the hardware in [°]C
"Correction Data"
"Version" Current version of the calibration data saved on the device
"Type"
●
Factory
The original factory calibration data are saved on the device.
●
Update
An improved set of calibration data is available and saved on the
device. (See Figure 6-5.)
"Date" Timestamp of creating and saving the calibration data on the device
"TCXO Date" Date of correction data for the internal reference
Using the R&S TSME device manager
To Next Page
Loading...