Rohde & Schwarz R&S TSME6 - Page 58

Configuring the R&S TSME6
R&S
®
TSME6
58User Manual 4900.0033.02 ─ 08
Figure 6-7: Tab "Downconverter Configuration"
IF Output Receiver Configuration
Specify the configuration of the IF output connectors of the R&S TSMExxDC/
TSMS53DC.
RF Input Antenna Configuration
●
Specify the configuration of the RF input antenna connectors of the R&S
TSME30DC.
– "Bypass Antenna (< 6 GHz)"
– "mmWave Antenna 1 (24 GHz to 27.5 GHz)"
– "mmWave Antenna 2 (27 GHz to 30 GHz)"
For R&S ViCom and ROMES, the API allows only the configuration of frequencies
of activated antenna ports.
NOTE: For the overlapping frequency range 27 GHz to 27.5 GHz, the "mmWave
Antenna 1" is used by default.
●
Specify the configuration of the RF input antenna connectors of the R&S
TSME44DC.
– "Bypass Antenna (< 6 GHz)"
– "mmWave Antenna 1 (24 GHz to 44 GHz)"
ForR&S ViCom and ROMES, the API allows only the configuration of frequencies
of activated antenna ports.
●
Specify the configuration of the RF input antenna connectors of the R&S
TSMS53DCDC.
– "Bypass Antenna (10 MHz to 17 GHz)"
– "mmWave Antenna 1 (17 GHz to 53 GHz)"
Using the R&S TSME device manager