Safety and regulatory information
R&S
®
TSME6
8User Manual 4900.0033.02 ─ 08
Connecting the product
Before connecting the interfaces and measuring inputs of the product to other products
or electrical circuits, make sure that the other products or electrical circuits provide
special protection against electric shock. This protection principle is referred to as
SELV (safety extra-low voltage) and is based on a low voltage level and increased
insulation. Exceptions are indicated by a measurement category on the product and
given in the specifications document.
Operating the product
The product is intended for mobile use. The maximum weight of the product is provi-
ded in the specifications document. If the product casing is not waterproof, use an ade-
quate weather protection to carry the product outdoors with you.
When operating the product on a mobile platform, such as a vehicle, aircraft or drone,
make sure that the product is properly secured. Refer to the instructions provided by
the manufacturer of the mobile platform. If stacking is possible, secure the whole stack
of products so that they cannot fall over and cause injury.
Observe the ambient conditions such as altitude, operating temperature and climatic
loads; see the specifications document.
Due to their exposed location, mobile communications systems are at risk of damage
from lightning. This also poses a risk to persons nearby. When the risk of lightning is
present, remove antennas from exposed locations, e.g. vehicle roofs. Do not operate
the product until the lightning risk has passed.
Connecting to power
The product runs on DC voltage. For the specifications of the supply voltage for the
product, refer to the specifications document. Only connect the product to a power
source that provides a protection against electric shock.
Take the following measures for your safety:
●
If you connect the product to an external power supply, use one recommended in
the product documentation.
●
If you connect the product to a battery, observe the safety information delivered
with the battery.
●
Before switching on the product, ensure that the voltage and polarity indicated on
the product matches the available power source.
●
Only use intact cables and route them carefully so that they cannot be damaged.
Also ensure that nobody can trip over loose cables.
Meaning of safety labels
Safety labels on the product warn against potential hazards.
Potential hazard
Read the product documentation to avoid personal injury or product damage.
Safety instructions
To Next Page
Loading...