Roland E-66 - Bass Tone Selection

C) Press a button (1-8) in the
TONE select section [53] to
choose the corresponding Bank
number.
(Tones are stored in a Group
(‘A’ or ‘b’), Bank (1-8), and
Number position (1-8).
The display will show the
selected BANK number: the last
field (NUMBER) in the display
[31] is showing a flashing line,
as it awaits the entry of the final
digit; the Tone Number.
d) Press a button (1-8) in the
TONE select section [53] to
choose the Tone Number.
The display will indicate your
Tone selection until you select
another one, or move to a
different function.
To select Variations of the
Lower Tone, use the same
procedure as described in
UPPER TONE VARIATIONS
(page 41).
When selecting some Tones,
one of the available Variations
for the selected tone will
automatically be chosen.This is
again indicated by a dot (.)
beside the third digit in the
display.
The chart on page 103 shows
which tones (marked by an
asterisk) will be recalled
when selecting GROUP/BANK/
NUMBER.
Bass Tone
Selection
Press the SELECT buttons (- / 4)
[45] so the BASS LED lights,
then follow the procedure
described under UPPER TONE
Selection.