Roland E-66 - Panel descriptions; Basic I;O and Interface Connections

Panel descriptions
1) POWER Switch.
Turns the instrument on and off.
Your E-66 is provided with a
protection circuit which mutes
the output for a second or two
after the power is turned on).
2) DC IN Connector.
Connect the included AC adap-
tor to this power inlet. Use only
the supplied adaptor (ACJ or ASA
type). Using any other adaptor
could result in damage,
malfunction or electric shock.
3) PHONES Jack.
Connect stereo headphones (of
8-150 ohms- optional) to this
jack if you wish to play without
disturbing those around you.
4) FLOPPY DISK DRIVE.
It is used to read optional
Disks containing songs
(SMF type) or MUSIC STYLES
(MSD type).
5) MIDI IN/OUT/THRU
Sockets.
Use these sockets to connect
your E-66 to external MIDI
devices. (If you're using the
E-66 on its own, there is no
need to be concerned with
MIDI.)
6) SUSTAIN FOOTSWITCH
Jack.
Connect an optional Sustain
(damper) pedal to this jack.
(DP-2 or DP-6 type).
| | — FLOPPYDISK ——
___- ПЕМЕ (4)
5 THRU OUT IN
MIDI (5)
SUSTAIN
FOOT SWITCH (6)