Roland E-66 - Disk Handling and Precautions

Never attempt to remove a disk
from the drive while the drive is
operating (DISK LED (34) is red
damage could result to both the
disk and the drive (4).
Unless instructed to do
otherwise, remove any disk
from the drive before powering
up or down.
Floppy disks contain a plastic
disc coated with magnetic
particles; this is the magnetic
storage medium.
OBSERVE the following when
handling disks:
е Never touch the floppy's
internal disk.
* Do not subject floppy disks to
temperature extremes (e.g.,
direct sunlight in an enclosed
vehicle). Recommended tempe-
rature range: 10? to 50? C.
To insert a disk, push it firmly
(but gently) into the drive-it will
click into place. To remove a
disk, press the EJECT button
firmly. Do not use excessive
force to remove a disk which is
lodged in the drive.
The identification label should
be firmly fixed to the disk.
Should the label come loose
while the disk is in the drive, it
may be difficult to remove the
disk.
Floppy disks contain a ^write
protect" tab which can protect
the disk from accidental
erasure.
It is recommended that the tab
be kept in the PROTECT posi-
tion and moved to the WRITE
position only when you wish to
write new data onto the disk.
Floppy disks contain a ^write
protect" tab which can protect
the disk from accidental erasure.
It is recommended that the tab
be kept in the PROTECT
position and moved to the
WRITE position only when you
wish to write new data onto the
disk.
=
_____ FLOPPY DISK
O DRIVE (4
——
—--- DRIVE (4)
а