Roland FP-E50 - Page 43

Using the Chord Sequencer
4343
Setting the Transposition of a Pattern
(Transpose)
1. Use the Edit Menu to select “Transpose”, and then press
the [Enter] button.
The Transpose screen appears.
2. Use the [Dec] [Inc] buttons to set the amount of
transposition.
Parameter Value Explanation
Transpose -11–0–+11
This transposes a chord pattern in
semitones.
3. Press the [Exit] button to return to the previous screen.
Initializing a Pattern (Initialize Pattern)
1. Use the Edit Menu to select “Initialize Pattern”, and then
press the [Enter] button.
A conrmation message appears.
If you decide to cancel, select “Cancel” and press the [Enter] button.
2. Use the [
çç
] [
ææ
] buttons to select “OK”, and then press
the [Enter] button.
Once the data is saved, the message “Completed!” is shown and the display
returns to the previous screen.
MEMO
When a pattern is initialized, it becomes a four-measure pattern.
Refer to “Measure-related Settings (Measure)” (p. 41) for how to change
the number of measures.