Roland FP-E50 - Page 72

Convenient Functions (Utility)
7272
Exporting a Scene (Export Scene)
You can export the scene data to an SVD le.
1. You can connect a USB ash drive here.
2. On the Utility screen, use the [
ää
] [
åå
] buttons to select
“Import/Export” and press the [Enter] button.
3. Use the [
ää
] [
åå
] buttons to select “Export Scene” and
press the [Enter] button.
4. Use the [
ää
] [
åå
] buttons to select the scene you wish to
export, and press the [1] ([Piano])–[5] ([Other]) buttons
to select the appropriate check boxes.
How to select with the check marks
Controller Explanation
[1] Mark-
Removes the check mark and moves the
cursor forward one scene.
[2] Mark+
Adds a check mark and moves the cursor
forward one scene.
[3] Clear All Removes all check marks.
[4] Mark All Adds all check marks.
[5] Mark Toggle
Switches between adding and removing the
check marks.
5. Press the [Enter] button.
6. Conrm/edit the name of the le to export.
If you wish to edit the lename, follow the steps below.
Ø “Editing a Name (Rename Screen)” (p. 15)
7. Press the [Enter] button.
A conrmation message appears.
If you decide to cancel, select “Cancel” and press the [Enter] button.
MEMO
If the same lename already exists, a conrmation dialog box with the
message “Already Exist. Overwrite?” is shown, asking if you wish to
overwrite the lename.
8. Use the [
çç
] [
ææ
] buttons to select “OK”, and then press
the [Enter] button.
When export is nished, the message “Completed!” appears.
NOTE
Never turn o the power or disconnect the USB ash drive while the
“Executing…” display or a similar message is shown.