Roland FP-E50 - Page 74

Convenient Functions (Utility)
7474
Importing the Chord Pattern
(Import Chord Pattern)
You can import the chord pattern that were previously exported.
Saving the chord pattern to a USB ash drive
1. Prepare a CSV (chord pattern) le using the export
function on the FP-E50 which you’ll import into the
FP-E50.
2. Connect a USB ash drive to your computer.
* If this is the rst time you’re using the USB ash drive, format it on
the FP-E50.
Ø “Initializing a USB Flash Drive (Format USB Memory)” (p. 75)
3. Save the CSV le to the “ROLAND” folder on your USB
ash drive.
4. Remove the USB ash drive from your computer and
connect it to the FP-E50.
Importing chord pattern into the FP-E50
1. On the Utility screen, use the [
ää
] [
åå
] buttons to select
“Import/Export” and press the [Enter] button.
2. Use the [
ää
] [
åå
] buttons to select “Import Chord Pattern”
and press the [Enter] button.
NOTE
If the USB ash drive doesn’t contain any user chord patterns, “EMPTY”
appears on the screen and no data is imported.
3. Use the [
ää
] [
åå
] buttons to select the chord pattern you
wish to import, and press the [1] ([Piano])–[5] ([Other])
buttons to select the appropriate check boxes.
How to select with the check marks
Controller Explanation
[1] Mark-
Removes the check mark and moves the
cursor forward one pattern.
[2] Mark+
Adds a check mark and moves the cursor
forward one pattern.
[3] Clear All Removes all check marks.
[4] Mark All Adds all check marks.
[5] Mark Toggle
Switches between adding and removing the
check marks.
You can check the number of chord patterns onscreen (meaning the
number of chord patterns that are selected as the import source from all
chord patterns).
4. Press the [Enter] button.
The Destination screen appears.
Empty user chord patterns (shown in gray) are automatically marked. You
can select and deselect the marks.
5. Use the [
ää
] [
åå
] buttons to select the import
destination, and press the [1] ([Piano])–[5] ([Other])
buttons to select the appropriate check boxes.
6. Press the [Enter] button.
A conrmation message appears.
If you decide to cancel, select “Cancel” and press the [Enter] button.
MEMO
If data already exists in the user chord patterns on this instrument and at
least one of the data numbers being imported matches what’s already on
this instrument, a conrmation message asks you whether to overwrite the
data.
7. Use the [
çç
] [
ææ
] buttons to select “OK”, and then press
the [Enter] button.
When the import is nished, the message “Completed!” appears.
MEMO
Imported data is saved in the user chord patterns on this instrument.
NOTE
Never turn o the power or disconnect the USB ash drive while the
“Executing…” display or a similar message is shown.