Before you Start Playing
24
Straps
Attaching the Straps
1. Unpack the straps.
The FR-8x comes with two shoulder straps, both are tted with
Velcro strip at their ends. The Velcro strip is illustrated below:
2. Put the FR-8x on a stable surface as shown in the
illustration below. rning the Power On/O
Left Holder Ring
3. Slide the upper end (with the Roland brand) of one strap
through the left holder ring (see the illustration).
4. Attach the strap upper part to the Velcro layer below it.
5. Close the security clip to ensure that the strap cannot
come loose.
6. Repeat steps (3)~(5) for the other strap.
The upper strap ends should look as follows:
7. Slide the lower end of one strap through the right holder
ring as shown.
8. Attach the strap upper part to the Velcro layer below it.
9. Close the security clip to ensure that the strap cannot
come loose.
10. Adjust the length of your shoulder straps using the buckle
(see the illustration).
11. Repeat steps (7)~(10) for the other lower strap end.
12. Fasten the back strap.
13. Adjust the back strap length to your own correct
ergonomic position using the buckle.
Adjusting the Bass strap
The FR-8x bass strap, which is used to move the bellows in and out,
is made out of leather. Its slack can be adjusted according to your
preference by rotating the adjuster (see the illustration).
Turn it to one side to tighten the bass strap, and to the other to
To Next Page
Loading...
