Menu Options
92
Parameter Value Explanation
REVERB
0~127
Use these parameters to set the Reverb,
Chorus or Delay send levels (how
much eect should be applied to the
Orchestra 1 section).
CHORUS
DELAY
MFX O, On
Select “O” if you don’t need the MFX
processor.
MFX Type See the table below.
The FR-8x provides 84 dierent
multi-eect types, some of which are
combinations of two eects for added
exibility. This parameter allows you to
select the desired type.
The MFX available types are:
N. Mfx Type N. Mfx Type N. Mfx Type
1 Thru 29
OD Delay
57 VK Rotary
2 Stereo EQ 30
DST Cho
58 3D Chorus
3 Overdrive 31
DST Flgr
59 3D Flanger
4 Distortion 32
DST Delay
60 3D Step Flgr
5 Phaser 33
EH Chorus
61 Band Cho
6 Spectrum 34
EH Flanger
62 Band Flgr
7 Enhancer 35
EH Delay
63 B. Step Flgr
8 Auto Wah 36.
ChoDLY
64 VS Overdr.
9 Rotary 37
Flgr DLY
65 VS Distort.
10 Compress 38
CHO Flgr
66 GT AmpSim
11 Limiter 39 CHO/DLY 67 Gate
12 Hexa-Cho 40 Flgr/DLY 68 Long Delay
13 Trem Cho 41 CHO/Flgr 69 Serial Delay
14 Space-D 42 Isolator 70 M. Tap DLY
15 St. Chorus 43 Low Boost 71 Reverse DLY
16. St. Flanger 44 Super Filter 72 Shue DLY
17 StepFlanger 45 Step Filter 73 3D Delay
18 St. Delay 46 Humanizer 74 Long Delay
19 Mod. Delay 47 Speaker Sim 75 Tape Echo
20 3 Tap Delay 48 Step Phaser 76 LoFi Noise
21 4 Tap Delay 49 MLT Phaser 77 LoFi Comp
22 Time Delay 50 INF Phaser 78 LoFi Radio
23 2 Pitch Shift 51 Ring Modul 79 Telephone
24 FBK Pitch 52 Step Ring 80 Phonograph
25 Reverb 53 Tremolo 81 Step Pitch
26 Gate Reverb 54 Auto Pan 82 Symp Reso
27
ODChorus
55 Step Pan 83 VIB-OD-Rot
28
ODFlanger
56 Slicer 84 Center Can
10.3 VTW Lower Parameter (only for VTW
Organ Tone)
This page allows you to make additional detailed
settings for the Organ sound.
NOTE
The organ eects described below apply to all sections that use
VTW Organ sound.
Vibrato/Chorus
The vibrato eect cyclically modulates the pitch of organ sounds
(which is dierent from the Rotary eect).
Parameter Value Explanation
Vib/Cho Switch O, On
You can apply vibrato or chorus to the
organ sound.
Vib/Cho Type
V-1, V-2, V-3
C-1, C-2, C-3
The eect will intensify as the vibrato
type (V-1, V-2, V-3) or chorus type (C-1,
C-2, C-3) moves to a higher number
Vib/Cho Vintage ‘50, ‘60, ‘70
Tonewheel used in tonewheel organs of
1950, 1960, 1970.
Vib/Cho Level 0~127
Use this parameter to set the Vibrato or
chorus level.
Overdrive
This eect distorts the sound, giving it an “edge” and making it
suitable for hard rock and similar musical genres. See also the
“NOTE” under “Vibrato/Chorus”.
Parameter Value Explanation
Overdrive Switch O, On
Allows you to switch the overdrive eect
on or o.
Overdrive Drive 0~127
Species how strongly the sound is
distorted. A value toward 127 raise the
gain, adding distortion to the sound.
Overdrive Level 0~127
Species the level of the eect with
respect to the unprocessed organ signal.
Rotary
The eect in this section simulates the typical sound modulation
generated by a cabinet with rotating loudspeakers.
Most functions (start/stop, rotation speed selection, etc.), need to
be selected with an optional MIDI foot controller (e.g. FC-300) ( p.
107), Chin Switches ( p. 98) or Function Switches ( p. 106).
Parameter Value Explanation
Leakage Level 0~127
Species the level of the eect with
respect to the unprocessed organ signal.
Rotary Snd Level 0~127 You can adjust the level of rotary eect.
Rotary Snd
Reverb
0~127
Allows yo to specify the level of the
rotary signal that is transmitted to the
reverb eect.
Choose “0” if the sound should not be
processed by the organ reverb processor.
Rotary Snd
Chorus
0~127
Allows yo to specify the level of the
rotary signal that is transmitted to the
organ chorus eect.
Choose “0” if the sound should not
be processed by the organ chorus
processor.
Rotary Snd Delay 0~127
Allows yo to specify the level of the
rotary signal that is transmitted to the
organ delay eect. Choose “0” if the
sound should not be processed by the
organ delay processor.
10.4 MFX Edit (Not for VTW Organ Tone)
The parameters in this page depend on the MFX
type that you selected.
Select and set the desiderate parameter.
For details regarding MFX edit parameters refer to
the“Tone & Drum Kit List “ supplementary manual.
Download it from the Web http:/ www.roland.com/manuals/.