Roland JD-08 - Configuring the Effects; Effect A Settings

Configuring the Effects
34
Configuring the Effects
Here’s how to configure the effects.
1. Press the [EFFECTS] button.
The [EFFECTS] button lights up.
2. Use the [VALUE] knob to select the parameter to set, and press the [VALUE] knob.
The parameter setting screen appears.
3. Turn the [VALUE] knob to set the value, and press the [VALUE] knob.
4. When you are finished making the settings, press the [EXIT] button.
Step buttons
Item
Value
Explanation
[1]
SEQ.A
D.P.S.E.
–
E.S.P.D.
Configures the connection order for effect A.
“Effect A (p. 34)”
[2]
dS
Edits the distortion settings.
“Distortion (p. 34)”
[3]
PH
Edits the phaser settings.
“Phaser (p. 35)”
[4]
SP
Edits the spectrum settings.
“Spectrum (p. 35)”
[5]
EH
Edits the enhancer settings.
“Enhancer (p. 35)”
[6]
A.PAn
R64
–
L63
Sets the pan position of the effect A sound.
[7]
A.LEU
0
–
127
Sets the volume of effect A.
[8]
SEQ.B
C.D.R.
–
R.D.C.
Configures the connection order for effect B.
“Effect B (p. 36)”
[9]
dLy
Configures the delay settings.
“Delay (p. 36)”
[10]
Cho
Configures the chorus settings.
“Chorus (p. 37)”
[11]
rEU
Configures the reverb settings.
“Reverb (p. 37)”
[12]
B.bAL
Adjusts the volume balance between the dry (original sound) and effect sound for effect B.
100.0
Dry sound = 100 : Effect sound = 0
0.100
Dry sound = 0 : Effect sound = 100
[13]
B.LEU
0
–
127
Sets the volume of effect B.
You can also press a corresponding step button to select the parameter items.
Effect A
Recreates the effects included in group A of the JD-800.
Distortion
Step buttons
Parameter
Value
Explanation
[1]
DS.Sľ
OFF
,
On
Turns the distortion on/off.
[2]
TyPE
Sets the type of distortion.
N.drIJ
Softer distortion with a slightly darker sound.
O.drIJ
Distortion that resembles a vacuum tube amp being driven.