Configuring the Settings of This Unit
42
Part Settings
These parameters configure the overall settings for the parts.
Item Value Explanation
[1]
SEL
A
B
Selects the part to configure.
You can also select a part by holding down the [NOTE] button and pressing the [TONE A] or
[2]
P.UoL
0
127
Adjusts the part volume.
You can adjust this parameter for each pattern.
P.PAn
L
64
r
63
Sets the pan position for each part.
UoL
0
127
[5]
UnSn
OFF, On
When this is on, a certain number of sounds (set in each tone) are layered for a unison
effect.
[6]
PrtA
This sets the playing style for applying portamento.
norN
Portamento is always applied.
LEgA
Portamento is only applied when you play in legato style (playing one key and then playing
the next while holding down the first one).
[7]
Prt.t
0
100
When portamento is used, this sets the time taken for the pitch to change.
Higher settings make the pitch take longer when gliding to the next note.
[8]
LEGt
OFF
On
When this is turned on and you play a note while holding down the first note (legato style),
the second note you play sounds without its attack portion. This lets you smoothly connect
the pitches without a gap in the notes.
This effect is applied when [SOLO] button is on.
[9]
Aft.S
-36
-24
-12
12
Sets the aftertouch sensitivity.
To Next Page
Loading...
