Roland JD-08 - Phaser; Spectrum; Enhancer

Configuring the Effects
35
Step buttons
Parameter
Value
Explanation
C.drIJ
Distortion that emphasizes the high end.
N.dSt
Gives the feeling of distortion playing through a large amp.
L.dSt
Strong distortion with a bright sound.
Fa.dS
Thick distortion that emphasizes the low and high ends.
Fv.dS
Distortion that’s even more powerful than
Fa.dS
.
[3]
drIJ
0
–
100
Sets the amount of distortion.
[4]
LEU
0
–
100
Sets the distortion output level.
You can also press a corresponding step button to select the parameter items.
Phaser
Step
buttons
Parameter Value Explanation
[1]
PH.Sľ
OFF
,
On
Turns the phaser on/off.
[2]
NAn
50
–
980 (Hz), 1.0
–
15.0
(kHz)
Sets the basic frequency from which the sound is modulated with the
phaser effect.
[3]
rAtE
0.1
–
10.0
(Hz)
Sets the cycle of the phaser modulation.
[4]
dEP
0
–
100
Sets the depth of the phaser modulation.
[5]
rESo
0
–
100
Sets the amount of feedback for the phaser. Increasing the value creates
a more unusual sound.
[6]
NiX
0
–
100
Sets the volume of the phased sound.
You can also press a corresponding step button to select the parameter items.
Spectrum
Step buttons
Parameter
Value
Explanation
[1]
SP.Sľ
OFF, On
Turns the spectrum on/off.
[2]
bnd.1
-15
–
15 (dB)
Sets the gain (amount of boost/cut) in the 250 Hz range.
[3]
bnd.2
-15
–
15
(dB)
Sets the gain (amount of boost/cut) in the 500 Hz range.
[4]
bnd.3
-15
–
15
(dB)
Sets the gain (amount of boost/cut) in the 1000 Hz range.
[5]
bnd.4
-15
–
15
(dB)
Sets the gain (amount of boost/cut) in the 2000 Hz range.
[6]
bnd.5
-15
–
15
(dB)
Sets the gain (amount of boost/cut) in the 4000 Hz range.
[7]
bnd.6
-15
–
15
(dB)
Sets the gain (amount of boost/cut) in the 8000 Hz range.
[8]
ľidt
1
–
5
Sets the bandwidth for changing the levels, common to all bands.
You can also press a corresponding step button to select the parameter items.
Enhancer
Step
buttons
Parameter Value Explanation
[1]
EH.Sľ
OFF,
On
Turns the enhancer on/off.
[2]
SEnS
0
–
100
Sets how easily the enhancer effect is applied.
[3]
Nix
0
–
100
Sets the ratio at which the harmonics generated by the enhancer are mixed with the
original sound.
You can also press a corresponding step button to select the parameter items.