Selecting a Tone (Patch)
15
Selecting a Tone (Patch)
The settings for each tone are stored in a block of memory called a “patch.” By selecting (switching between) patches, you can use
a variety of sounds.
The patches are further organized by group (A–D), bank (1–8) and number (1–8), letting you save a total of 4 x 8 x 8 = 256 patches.
1.
Press the NUMBER [1]–[8] buttons.
This selects the patch.
You can use the [VALUE] knob to select from all of the patches in order.
● You can select separate patches for parts A and B. For details on the part settings, refer to “Part Settings (p. 42).”
To Next Page
Loading...
