Restoring the Settings (Restore)
40
Restoring the Settings (Restore)
You can use the backup data that you created on your computer to restore the settings of the JD-08.
1.
Connect your computer to the JD-08 with a USB cable.
2.
While holding down the [EXIT] button, turn on the power.
The JD-08 operates in USB mass storage mode. The JD-08 is recognized by your computer as an external storage device. It
takes around 20 seconds for the unit to be recognized.
3.
Open the “JD-08” on your computer.
The “BACKUP” folder is located in the JD-08.
4.
Delete the “BACKUP” folder.
5.
Copy (drag and drop) the backup file that you backed up on your computer to the “RESTORE” folder on
the JD-08.
6.
Disconnect the JD-08 from your computer.
If you’re using Windows, click the Safely Remove Hardware icon in the taskbar ( ) and then click “Eject JD-08.”
If you’re using macOS, drag the JD-08 icon to the trash.
7.
Press the [PAGE/TIE] button on the JD-08.
The restore operation begins, and the [PAGE/TIE] button blinks. “donE” is displayed once the restore operation is finished.
8.
Turn off the JD-08.
To Next Page
Loading...
