Roland RS-5 - Page 22

22
Playing the Sounds
fig.Q-12a
4
Use VALUE [-]/[+] to select “All.”
fig.Q-13
5
Press [ENTER].
The confirmation message appears.
fig.Q-14
6
Press [ENTER] once again to start the Factory Reset operation.
After the Factory Reset operation is finished, the display will indicate
“Completed.”
The [UTILITY] indicator goes out, and you are returned to the previous
screen.
5,64
• To cancel the Factory
Reset, press [EXIT].
• Even if the Factory Reset
operation is executed, the
display may be difficult
to read, depending on
the angle at which the
RS-5/9 is placed. When
this occur, adjust depth
of the display (p. 16).
When you want to return a portion of the User memory to factory
settings
• “Restoring the Factory Settings (Factory Reset)” (p. 117)