Roland RS-5 - Changing the Split Point

40
Playing Two Tones on the Keyboard
fig.Q-39a
4
Press [9] a number of times to select “Upper Part” or “Lower
Part.”
fig.Q-40
5
Press VALUE [-]/[+] to select the value (1–16).
6
Press [EDIT].
The [EDIT] indicator goes out, and you are returned to the previous screen.
Changing the Split Point
When Key Mode is set to Split, you can set the key that divides the keyboard
into two separate ranges anywhere from C2 to C#7.
fig.Q-32
65 4
If you hold down [SHIFT]
and press [9], you will
return to the previous item.
Which Part Is Used in Single Mode?
When Key Mode is set to Single, the Upper Part is used.
Therefore, take care not to press PART [ ]/[ ] and switch the Part
while in Single Mode, or the “Upper Part” value will be overwritten.
The split point can be set
individually for each
Performance (p. 56).
C4 (Split Point)
UpperLower