21
Playing the Sounds
Playing the Sounds
Restoring the Factory Settings
(Factory Reset)
When learning how to use the RS-5/9, it’s a good idea to reset it to its factory
settings to ensure that its operation matches the behavior described in its
manuals.
fig.Q-11
1
Press [UTILITY], getting the indicator to light.
2
Use VALUE [-]/[+] to select “Factory Reset.”
fig.Q-12
3
Press [ENTER].
When this operation is
executed, the settings
stored in the User Area
(where the User Tones and
other Tones you have
created are stored) as well
as the System setup
settings are lost. If you
want to keep this data, save
it to an external sequencer
or computer using “Bulk
Dump” (p. 115).
Notes
fig.(!)
When data is being written to the User Memory, the message “KEEP
POWER ON!” appears in the display; be sure not to turn off the power while
this message is displayed.
If the power is turned off or interrupted while data is being written to
memory, the internal data may become corrupted, and you may not be able
to turn the power back on. If you have confirmed that internal data has been
lost, or if a similar problem exists, consult your Roland dealer or Roland
Service. Note, however, that Roland assumes no liability, including
compensation, for consequences arising from loss of data.
321
To Next Page
Loading...
