38
Playing Two Tones on the Keyboard
Selecting Tones by Specifying the Group and
Number
fig.Q-37
1
Press [TONE CATEGORY] to make the indicator goes out.
2
Press PART [ ]/[ ] to move the cursor to the Part whose
Tone or Drum Set you want to switch.
fig.Q-38exp
The above figure is an example where the Upper Part is selected.
Selecting Categories from the Full List
In Step 3, if you hold down [TONE CATEGORY] and press a numerical key
([1]–[0]), the Category selection screen is displayed.
The indicator will begin blinking, instead of lighting steadily.
fig.Q-17
Press the numeric keys ([1]–[0]) a number of times, or press VALUE [-]/[+],
to select the Category.
Pressing [TONE CATEGORY] or [EXIT] returns you to the original screen
(the screen displayed in Step 2).
The indicator changes from blinking to lit.
45231
Lower Part
Upper Part
Current Part
To Next Page
Loading...
