72
Chapter 4. Changing Tones in Real Time
* When set to MFX PARAMETER 1 or MFX PARAMETER
2, be sure to note the following.
• When the multi-effects Type is set to 01: STEREO EQ (p.
82) or 41: LOFI (p. 106), Level is changed regardless of
whether MFX PARAMETER 1 or MFX PARAMETER 2 is
selected.
• When the multi-effects Type is set to 22: 2VOICE PITCH
SHIFTER (p. 96), the two parameters are changed
simultaneously.
• When the multi-effects Type is set to 23: FBK PITCH
SHIFTER (p. 97), the two parameters are changed
simultaneously when MFX PARAMETER 1 is selected.
• he following describes which Part or Parts are enabled
according to the Source setting (p. 80).
UPPER = Upper
LOWER = Lower
PERFORMANCE = All Parts
* When making the LFO RATE, LFO DEPTH or LFO DELAY
settings, the effect achieved differs depending on whether [LFO
ON/OFF] is on or off. When [LFO ON/OFF] is off, the LFO
alters the pitch (vibrato effect). When [LFO ON/OFF] is on,
the LFO changes the Filter Cutoff frequency (wah effect).
Different Modulation lever settings can be made for each
individual Performance.
1. Press [EDIT], getting the indicator to light.
2. Use VALUE [-]/[+] to select “Tone/Drum/
PFMCommon.”
3. Press [ENTER].
4. Press the numeric key [5] several times to select “MOD.”
fig.R04-03
* If you hold down [SHIFT] and press [5], you will return to the
previous item.
5. Use VALUE [-]/[+] to set the value.
6. Press [EDIT].
The [EDIT] indicator goes out, and you are returned to
the previous screen.
To Next Page
Loading...
