117
Chapter 5 Playing Along with Patterns
Chapter 5
MEASURE: ALL, First Measure-Last Measure
ALL:
This deletes all measures.
First Measure: 1–99
This specifies the measure at which deletion begins.
Last Measure: 1–99
This specifies the measure at which deletion is to end.
For example, to delete the measures from Measure 4 to
the end of Measure 6, specify as shown below.
fig.06-054
Erasing a pattern [ERASE]
This erases the pattern. Performance data is erased, while
beat, measure length, and other settings are left intact.
fig.06-062a.e
fig.06062b
1. Press [PATTERN], then [F3 ( MENU)].
[PATTERN] lights, and a pop-up menu appears.
2. Press [INC/+] or [DEC/-], rotate the VALUE dial, or
press CURSOR [ ] or [ ] to move the cursor to
“EDIT.”
3. Press [F3] to confirm your choice.
The “PATTERN EDIT” screen appears.
4. Press CURSOR [ ] to move the cursor to “EDIT.”
5. Press [INC/+] or [DEC/-] or rotate the VALUE dial to
select “ERASE.”
The “ERASE” screen appears.
6. Press CURSOR [ ] to move the cursor to “PATTERN.”
7. Press [INC/+] or [DEC/-] or rotate the VALUE dial to
select the pattern to be erased.
8. Press [F3 (EXEC)].
The confirmation screen appears.
fig.06-057
9. Again, press [F3 (EXEC)].
Press [F1 (CANCEL)] to cancel the operation.
PATTERN: 701–800
Select the pattern to be erased.
Indicated from left to right are the pattern number and
pattern name.
Erasing Unneeded Data to Make
a Measure Blank
This erases portions of the pattern, in measure units. The
erased portions become blank measures.
fig.06-062.e
Although the data is erased, the pattern length is
unchanged.
ffig.06-056
1. Follow the procedures in Steps 1.–7. of “Erasing a
pattern [ERASE]” (p. 117) to specify the pattern.
2. Press [F2 (MEAS)].
The “ERASE MEASURE” screen appears.
3. Press CURSOR [ ] to move the cursor to “PART.”
4. Press [INC/+] or [DEC/-] or rotate the VALUE dial to
specify the part to be erased.
5. Press CURSOR [ ] to move the cursor to “MEASURE.”
Indicated from the left is the first measure, followed by
the last measure.
Press CURSOR [ ] or [ ] to move the cursor to the
item to be selected.
12 643785
12 643785
12 643785
12 643785
To Next Page
Loading...
