38
Specifying Pads and Performing
Setting Head Tension
When connecting the PD-80, PD-80R, PD-100, or PD-120 to TRIGGER
INPUT 3 (SNARE), adjustments are required for accurate detection of the
point where the pad is struck. The tension of the head may change when the
pad has been used for a length of time. If this occurs, use the following
procedure to make adjustments as necessary.
fig.Q2-014
1
Press [SETUP].
[SETUP] lights, and the “SETUP” screen appears.
fig.Q2-016
2
Press [F1 (TRIG)].
The “TRIGGER” screen appears.
fig.Q2-017
2 4
1 9
6
To Next Page
Loading...
