39
Specifying Pads and Performing
Quick Start
3
Check to make sure that the TRIGGER TYPE (pad name) for
TRIGGER INPUT 3 (SNARE) is either “8 A” (PD-80), “8RA” (PD-
80R), “10A” (PD-100), or “12A” (PD-120).
fig.Q2-015.e
4
Press [F3 (H.ADJ)].
The “HEAD TENSION” screen appears.
fig.Q2-018
5
Strike the TRIGGER INPUT 3 (SNARE) pad.
The TRIGGER INPUT 3 (SNARE) settings screen appears.
fig.Q2-019
6
Press [INC/+] or [DEC/-] or rotate the VALUE dial to make the setting.
A setting of “LOOSE” creates a weaker tension, a setting of “NORMAL”
gives a standard tension, and “TIGHT” provides a stronger tension. For
now, set this to “NORMAL.”
7
Use your drumstick to strike the PD-80, PD-80R, PD-100, or PD-120
head.
Strike a position approximately 1 inch (3 cm) from the rim.
The indicator in the lower left of the display will indicate how far off the
adjustment is.
fig.Q2-020.e
If a different TRIGGER
TYPE is indicated, refer to
p. 36, then set the
TRIGGER TYPE.
If a pad other than that
connected to TRIGGER
INPUT 3 (SNARE) is
struck, the screen from Step
4, crossed out, then appears
in the display.
Be sure to strike the pad
evenly. Please watch the
velocity indicator.
1 inch (3 cm)
Strike here
Tuning bolt
To Next Page
Loading...
