27
Before You Begin Playing
Quick Start
Connecting Pads and Pedals
Using the provided cables, connect your pads, hi-hat control pedal, and kick
trigger units as shown in the diagram.
Use the TRIGGER INPUT jack number on the TD-8’s rear panel matching
the number in the figure to connect the cable.
fig.Q02.e
Before using pads with
mesh heads (PD-80, PD-
80R, PD-100, PD-120, KD-
80, or KD-120), be sure to
adjust the head tension.
Striking the head when the
head tension is loose may
damage the sensor.
For more information on
adjusting the head tension,
refer to the owner’s manual
for each pad.
To enjoy optimum
expression in your
performances, we
recommend the use of the
Roland line of pads (PD-5,
PD-7, PD-9, PD-80, PD-80R,
PD-100, and PD-120) and
kick trigger units (KD-7,
KD-80, and KD-120).
TD-8 Rear panel
To Next Page
Loading...
