170
Troubleshooting
Sound of Pattern or Song is Different
• Have any part settings been changed? ([PATTERN] →
[F2 ( PART)] → [SETUP])
→ Refer to p. 102 and make the necessary part settings.
You can change percussion set instrument settings can be
changed, even when the Pattern Lock (p. 119) is set to “ON.”
Playback Stops Immediately After
Beginning
• Is “TAP” selected for the pattern’s PLAY TYPE?
([PATTERN] → [F3 ( MENU)] → [FUNC] → [F2
(TYPE)] → “PLAY TYPE”)
→ Press [INC/+] or [DEC/-] or rotate the VALUE dial to
select a setting other than “TAP” (p. 100).
“TAP” refers to the convenient playback function in Pad
Pattern (tapping the pad causes the pattern to be played
back) (p. 139).
Pattern Assigned to Pad Not Being
Played Back
• Is the song selected?
→ When the song is selected, patterns set to “1SHOT” or
“LOOP” cannot be played back with the Pad Pattern
function (p. 139). Only patterns set to “TAP” can be
played back.
Cannot Record or Edit User Pattern
• Is Pattern Lock turned on? ([PATTERN] → [F3
( MENU)] → [LOCK])
→ Press [INC/+] or [DEC/-] or rotate the VALUE dial to
set this to “OFF” (p. 119).
Click Issues
No Click Sound
• Is the [CLICK] button lit?
→ Press [CLICK] to light the button (p. 94).
• Has the [GROUP FADERS] [CLICK] slider been
lowered?
→ Press the [FADERS] button. The indicator to the lower
left of the button is lights; bring up the [CLICK] slider
(furthest to the right) (p. 21).
• Is the click sound output destination correct? ([CLICK]
→ [F2 (INST)] → “OUTPUT”)
→ When set to “BOTH,” the click sound is output to the
MASTER OUTPUT and headphones; when set to
“PHONES,” the click sound is output to the
headphones (p. 95).
To Next Page
Loading...
