Roland V-Drums TD-8 - About the PATTERN Screen; Choosing with List Display

98
Chapter 5 Playing Along with Patterns
About the “PATTERN” Screen
fig.06-003
1 Pattern Number
Currently selected pattern number.
2 Measure Number
Playback begins from the measure indicated here when
[PLAY/STOP] is pressed.
3 Pattern Category
Shows the category of the currently selected pattern.
4 Pattern Number and Name
Shows the number and name of the currently selected
pattern. When choosing the empty pattern, an asterisk
( ) appears in the left of pattern name.
5 Pattern Type
“ ” is displayed with Preset patterns and patterns in
which Pattern Lock (p. 119) is set to “ON.”
6 Playback Method Setting (p. 100)
Indicates the pattern playback type.
7 Sequencer Status
Indicates the status of the pattern: playback “ ,” stop
“ ,” record “ ” (p. 108), rehearsal “ ” (p.
110), erase “ ” (p. 110).
8 Part Mute Status (p. 108)
The muted part icon is cleared.
Function buttons [F1]–[F3] are used for various functions
as explained below.
When you have finished making the settings, press
[PATTERN] to bring up this screen. This prevents data
from being overwritten inadvertently during
performance.
Choosing with List Display
Like the “PATTERN” page, here you can select patterns from
a list of pattern names.
Beat, measure length (LEN), pattern playback type, category
name, pattern number, and pattern name are displayed.
fig.06-004
1. Press [PATTERN], then [F1 (LIST)].
[PATTERN] lights, and the “PATTERN LIST” screen
appears.
2. Press [INC/+] or [DEC/-], rotate the VALUE dial, or
press CURSOR [ ] or [ ] to choose the pattern.
While holding down [SHIFT], press [INC/+] or [DEC/-]
or rotate the VALUE dial to switch the display page by
page.
3. Press [PATTERN].
The “PATTERN” screen appears.
You can select the category name by pressing [F1
(CTEGRY)].
5
7
62
1
3
4
8