Roland V-Drums TD-8 - Page 198

198
Parameter List
ADVNCD (ADVANCED TRIGGER PARAMETERS)
*1: OFF, 20, 25, 30, 35, 40, 45, 50, 55, 60, 65, 70, 75, 80
MIDI
*1: OFF, MOD ( 1), FOOT ( 4), GEN1 (16), GEN2 (17)
*2: OFF, MOD ( 1), GEN1 (16), GEN2 (17)
*3: ALL, SETUP, DRUM KIT (ALL, 1–64), USER PERCUSSION SET (ALL, USER 1–2), USR PTNS&SONGS
+: This setting cannot be made in GM mode.
PREVIEW
OTHERS
*1: MAS, M_L, M_R, DIR, D_L, D_R, M&D
*2: KIT SELECT, SEQ SELECT, PLAY SELECT, ASSIGNABLE (KIT#DEC, KIT#INC, SEQ# DEC, SEQ# INC, SEQ TOP, PLAY/STOP,
SEQ BWD, SEQ FWD)
*3: OFF, KIT SELECT, SEQ SELECT, ASSIGNABLE (OFF, KIT# DEC, KIT# INC, SEQ# DEC, SEQ# INC)
*4: ALL, THIS DRUM KIT, ALL DRUM KITS, ALL PERC SETS, ALL PATTERNS, ALL SONGS
Parameter Value
SCAN TIME (p. 131) Scan time 0–4.0 (0.1 ms steps)
RETRIGCANCL (p. 132) Retrigger cancel 1–16
MASK TIME (p. 132) Mask time 0–64 (1 ms steps)
CROSSTALK (p. 133) Crosstalk cancel *1
CROSS STICK (p. 133) Cross stick sensitivity 1–16
Parameter Value
TX/RX CHANNEL (p. 154) TX/RX channel CH1–CH16, OFF +
NOTE CHASE (p. 136) Note chase OFF, ON +
LOCAL CONTROL (p. 155) Local control OFF, ON +
SYNC MODE (p. 162) Sync mode INT, EXT, REMOTE +
CH10 PRIORITY (p. 154) Channel 10 priority KIT, PERC +
PEDAL DATA THIN (p. 156) Pedal data thin OFF, 1, 2 +
PEDAL CC (p. 161) Pedal CC *1 +
ZONE CC (p. 162) Zone CC *2 +
GM MODE (p. 159) GM mode OFF, ON
RX GM ON (p. 160) RX GM on OFF, ON
SOFT THRU (p. 153) Soft through OFF, ON
DEVICE ID (p. 150) Device ID 1–32
KIT PROG (p. 157) Drum kit program change 1–128 +
TX (p. 155) Drum kit TX switch OFF, ON +
RX (p. 155) Drum kit RX switch OFF, ON +
PERC PROG (p. 158) Percussion set program change 1–128 +
BULK (p. 149) Bulk dump *3
Parameter Value
VELOCITY 1 (p. 148) Velocity 1 0–127
VELOCITY 2 (p. 148) Velocity 2 0–127
VELOCITY 3 (p. 148) Velocity 3 0–127
Parameter Value
OUTPUT ASSIGN (p. 137) Output assign *1
FOOT (p. 144) Foot switch *2
PAD (p. 142) Pad switch *3
LCD CONTRAST (p. 135) LCD contrast 1–16
MASTER TUNE (p. 135) Master tune 415.3–466.2
FACTORY RESET (p. 172) Factory reset *4