Roland VS-2480 - Page 13

2—Version Two Enhancements
Roland VS-2480 Owner’s Manual, Version Two Addendum www.RolandUS.com 13
automatically selects the same V-Track on the next-highest track as the destination
for its right side.
8. If you’d like to select a different right-side destination, set R-Ch DESTINATION
TRACK as desired.
9. The CAPTURE TO parameter allows you to place the captured audio at the desired
time location on the destination V-Tracks. You can place the captured audio:
• to Zero —at project time location 00h00m00s00f.
• to Last Phrs:0S —at the end of the last phrase on the destination V-Tracks.
• to Last Phrs:2S —two seconds after the last phrase on the destination V-Tracks.
• to Last Phrs:4S —four seconds after the last phrase on the destination V-Tracks.
10. Set CD TRACK CAPTURE OFFSET to the time at which you want to begin
capturing audio from the selected CD track. If you want to start at the beginning of
the CD track, select Start of Track. Otherwise, dial in the distance from the start of
the track at which you want the capture to begin.
11. The CD TRACK CAPTURE LENGTH parameter sets the amount of audio to be
captured from the CD track after the selected CD TRACK CAPTURE OFFSET time.
To capture the remainder of the CD track’s audio, set the parameter to Whole 1
Track. Otherwise, set it as desired.
12. Press F5 (OK).
13. Read the displayed message regarding copyright, and then press ENTER/YES to
proceed.
If you selected empty matching V-Tracks on Tracks 23 and 24 in Steps 7 and 8—or on
Tracks 15 and 16 in an M16 or M24 project—the VS-2480 can capture the CD audio
as CDR-mode mastering tracks that you can burn directly to a new audio CD. If you
selected another pair of destination tracks, skip to Step 13.
14. When the VS-2480 displays “Capture to Mastering Tr. In CDR Mode?” press
ENTER/YES if you want to capture the audio in CDR mode, or EXIT/NO to capture
it using the project’s normal recording mode.
15. Read the displayed message about licensing, and press ENTER/YES to proceed.
The capture process begins and the display shows “CD Capture...”
16. To exit CD CAPTURE, press F6 (EXIT).
To Pause or Cancel an Ongoing CD Capture Operation
You can pause or cancel a CD Capture operation while it’s taking place:
1. Press EXIT/NO—”Abort?” is displayed.
2. Press ENTER/YES to cancel the operation, or EXIT/NO to resume it.
If you want to burn a new audio CD from the captured audio, select a matching pair of
empty V-Tracks on Tracks 23 and 24 as your destination—the VS-2480 can capture the
audio directly into CDR mode as described below. If your project uses the M16 or M24
recording mode, select matching V-Tracks on Tracks 15 and 16.
If the destination selected in Step 5 already contains CDR-recorded audio, this
parameter cannot be manually set.
If your project uses the CDR recording mode, select matching, empty destination
V-Tracks. Failure to do so will result in an “Illegal Track Pair!” error message when you
attempt to execute the capture.
You can set the CD TRACK CAPTURE OFFSET on the fly as you listen to the selected
CD track. Press PLAY to begin playback, and press F1 (NOW) when you reach the
moment at which you want to start the capture.