5—VGA Main Display Home Screen
44 www.RolandUS.com Roland VS-2480 Owner’s Manual, Version Two Addendum
The color of each Aux bus’s slider provides helpful information at a glance. When a
slider’s:
• blue—the send is turned on and the bus is set to Post.
• red—the send is turned on and the bus is set to Pre.
• gray—the send is turned off.
When odd/even Aux busses are linked, the even-numbered bus’s slider is replaced by a
panning handle, as described on Page 67.
22. Status Toggles
Beneath the track control areas are five status toggle buttons. You can click each button
to toggle the setting of the entire column of buttons directly above it.
The Playlist’s Measure Bar
Just above the playlist is a gray strip called the “measure bar” (Page 38). The lines in the
bar show the project measures as defined by the project tempo map (Owner’s Manual
Page 312). The time bar also contains markers, CD track markers, edit point flags,
punch points and loop points.
When you change an Aux bus’s pre/post setting, you’re setting the pre/post
configuration of the Aux bus for any channel that’s using it, as described on Owner’s
Manual Page 153.
Click this status toggle: To:
MUTE un-mute all currently muted tracks.
SOLO un-solo all currently soloed tracks.
AUTOMIX STATUS set the status of all Automix tracks to the same value.
PHRASE SEQ
STATUS
set the phrase sequencer status of all phrase sequencer tracks
to the same value.
TRACK STATUS set the TRACK STATUS of all tracks to the same value.
MUTE status toggle TRACK STATUS toggle
SOLO status toggle PHRASE SEQ STATUS toggle
AUTOMIX STATUS
Marker
Auto Punch Points Loop Points
Edit Points
IN OUT FROM TO
Punch in Punch out Loop endLoop start
When Auto Punch is on, a red bar
connects the punch points.
When looping is on, a blue loop box
connects the start and end points.
CD Track Marker
To Next Page
Loading...
