5—VGA Main Display Home Screen
Roland VS-2480 Owner’s Manual, Version Two Addendum www.RolandUS.com 43
15. FX Ins Selector
16. DYNAMICS (DYN) Switch and Overview
17. EQ Switch and Overview
18. DIR (DIRECT) 1-8 Selector
19. MIX Button
20. P.PAD Switch
21. AUX Send Controls
The AUX send controls include the following parameters:
• Send level—drag a slider to set the track channel’s Aux send level to the
corresponding Aux bus (See Owner’s Manual Page 152). The send level appears to
the right of the slider in dB. When Aux busses are linked, the even-numbered bus’s
send control is replaced by a panning handle, described on Page 67.
• Send status—turns the Aux send to each bus on or off. See Owner’s Manual Page 152.
• Pre/post switch—sets the pre or post configuration of each Aux bus. See Owner’s
Manual Page 153.
Turn on the track channel’s dynamics processor by clicking the DYN
switch. The current dynamics shape is shown graphically next to the
switch—when the switch is on, the shape becomes blue.
You set up a channel’s dynamics processing by drawing the desired shape with your
mouse in the CH VIEW screen as described on Page 57.
Turn on the track channel’s EQ by clicking the EQ switch. The
current EQ curve appears to the right of the switch—when the
switch is on, the curve turns blue.
You can set up a channel’s EQ by drawing the desired curve with your mouse in the CH
VIEW screen, as described on Page 57.
To assign the track channel to a Direct bus, click the desired Direct
bus’s number so it lights.
Turn MIX on to send the track channel’s signal into the MASTER
bus, the main stereo mix. Turn it off to remove it from the mix.
P. PAD combines the CH EDIT PhrPAD and PlyMod parameters.
Click to the right of P.PAD to select the desired type of phrase pad
playback method or turn the track channel’s phrase pad off.
Send level
Send status
Pre/post switch
To Next Page
Loading...
