Roland VS-2480 - Input Mixer;Master Block View; Input Channel Strips

7—Mixer Views
Roland VS-2480 Owner’s Manual, Version Two Addendum www.RolandUS.com 65
Input Mixer/Master Block View
Select INPUT MIXER/MASTER BLOCK from the MIXER menu to view all of the
VS-2480’s 24 input channel strips and MASTER BLOCK settings at once on the VGA.
Input Channel Strips
1. DYNAMICS (DYN) On/Off
2. EQ On/Off
3. AUX Send Sliders
4. MUTE (M) Button
5. SOLO (S) Button
6. AUTOMIX STATUS (A) Button
Click this button to turn the channel’s dynamics processor on—so the
button’s lit—or off. See Page 57.
To turn the channel’s EQ on or off, click this button. When it’s lit, the
EQ’s on. See Page 57.
Set the amount of the channel’s signal sent to an Aux bus by adjusting
the corresponding AUX send slider. With linked Aux busses, a panning
handle replaces the even-numbered Aux bus’s slider (Page 67).
To mute the channel, click this button so it’s lit. To un-mute the channel,
click the button again.
To solo the channel, click the SOLO button to light it. To un-solo the
channel, click the button again.
When Automix is turned on, repeatedly click the AUTOMIX STATUS
button to set the channel’s Automix status.
Master BlockInput Mixer
FADER
button
indicator
1.
2.
3.
5.
7.
8.
9.
4.
6.
152
142
142
327