Roland VS-2480 - FX Return Channel Strips

7—Mixer Views
Roland VS-2480 Owner’s Manual, Version Two Addendum www.RolandUS.com 69
FX Return Channel Strips
1. ASSIGN Button
2. Algorithm View Button
3. AUX Send Sliders
4. MUTE (M) Button
5. SOLO (S) Button
6. AUTOMIX STATUS (A) Button
7. BAL (Balance) Knob
8. Channel Fader
9. MONO Switch
To designate an Aux bus as the send assigned to the
channel’s effect processor, click this button and select
the desired bus from the pop-up menu.
This button shows the name of the channel’s processor
and its currently selected effect patch. Click the button
to display the Algorithm View screen from which you
can select a new patch or edit the current patch.
Set the amount of the channel’s signal sent to an Aux bus by adjusting
the corresponding AUX send slider. With linked Aux busses, a panning
handle replaces the even-numbered Aux bus’s slider (Page 67).
To mute the channel, click this button so it’s lit. To un-mute the channel,
click the button again.
To solo the channel, click the SOLO button to light it. To un-solo the
channel, click the button again.
When Automix is turned on, repeatedly click the AUTOMIX STATUS
button to set the channel’s Automix status.
Set the stereo position of the channel in the main MASTER bus mix by
dragging the BAL knob up or down as desired.
The position of the channel fader sets the level of signal coming out of
the channel. Moving the onscreen fader is the same as moving the
channel’s physical fader on the VS-2480.
Click this button—so it lights—to collapse the effect processor’s
stereo output to a mono signal.
1.
2.
3.
5.
7.
8.
9.
4.
6.
228
221
230
142
142
327
229
230
228