Roland VS-2480 - Page 68

7—Mixer Views
68 www.RolandUS.com Roland VS-2480 Owner’s Manual, Version Two Addendum
3. AUX Send Sliders
4. MUTE (M) Button
5. SOLO (S) Button
6. AUTOMIX STATUS (A) Button
7. PHRASE SEQ STATUS (P) Button
8. PAN Knob
9. TRACK STATUS Button
10. Channel Fader
11. LINK Switch
Set the amount of the channel’s signal sent to an Aux bus by adjusting
the corresponding AUX send slider. With linked Aux busses, a panning
handle replaces the even-numbered Aux bus’s slider (Page 67).
To mute the channel, click this button so it’s lit. To un-mute the channel,
click the button again.
To solo the channel, click the SOLO button to light it. To un-solo the
channel, click the button again.
When Automix is turned on, repeatedly click the AUTOMIX STATUS
button to set the channel’s Automix status.
When the phrase sequencer is turned on, repeatedly click the PHRASE
SEQ STATUS button to set the track channel’s phrase sequencer status.
Set the stereo position of the channel in the main MASTER bus mix by
dragging the PAN knob up or down as desired.
Repeatedly click the TRACK STATUS button to set status of the
corresponding hard disk recorder track. This is the same thing as
pressing the track’s TRACK STATUS button on the VS-2480.
The position of the channel fader sets the level of signal coming out of
the channel. Moving the onscreen fader is the same as moving the
channel’s physical fader on the VS-2480.
LINK combines the CH EDIT ChLink and F.LINK parameters. Click
to the right of “LINK” and select the desired type of linking from the
pop-up menu, or turn off linking. The LINK switch occupies the
combined lower edge of both of the channels it controls.
152
142
142
327
275
156
178
154
152, 155