Roland VS-2480 - Master Block Strips

7—Mixer Views
66 www.RolandUS.com Roland VS-2480 Owner’s Manual, Version Two Addendum
7. PAN Knob
8. Channel Fader
9. LINK Switch
Master Block Strips
The Master Block strips contain Direct bus parameters (Owner’s Manual Page 208) and
Aux bus controls (Owner’s Manual Page 205).
Direct Bus Parameters
1. Source
Click Source and choose the signal you want to assign to the Direct bus.
2. Pre/Post Switch
This sets the Direct bus to receive a channel’s signal before or after the channel fader.
3. AUTOMIX STATUS (A) Button
When Automix is on, repeatedly click this button to set the Direct bus’ Automix status.
4. Final Level Knob
Drag this knob up or down to set the final level of the Direct bus.
Aux Bus Parameters
1. PRE/POST Switch
Click the PRE/PST switch to configure the Aux bus to accept channel
signals from before or after the channel faders.
2. AUTOMIX STATUS (A) Button
When Automix is on, repeatedly click the AUTOMIX STATUS button to
set the Aux bus’s Automix status.
3. Linked Aux Bus Balance
When an odd/even pair of aux busses is linked, this knob become active
(see below) and allows you to set the relative levels of the linked busses.
Set the stereo position of the channel in the main MASTER bus mix by
dragging the PAN knob up or down as desired.
The position of the channel fader sets the level of signal coming out of
the channel. Moving it is the same as moving the channel’s physical
fader on the VS-2480. The channel’s level is displayed below the fader.
LINK combines the CH EDIT ChLink and F.LINK parameters. Click
to the right of “LINK” and select the desired type of linking from the
pop-up menu, or turn off linking. The LINK switch occupies the
combined lower edge of both of the channels it controls.
156
154
152, 155
1.
2.
3.
4.
1.
2.
3.
4.
5.