8—VGA Main Display EZ ROUTING Screen
Roland VS-2480 Owner’s Manual, Version Two Addendum www.RolandUS.com 81
To change or delete an existing connection:
1. Position the mouse cursor over the desired recording track until the cursor changes
to a pointing finger.
2. Click and drag the mouse left or right to select a new track or all the way left to
delete the connection.
Routing Signals to Outputs Using a Mouse
You can route any busses or tracks to the desired output jacks or connectors in the
OUTPUT ASSIGN pane using the same principles described on Owner’s Manual Page
287. To route tracks to output jacks, click the TRACK DIRECT OUT button (Owner’s
Manual Page 289) so it lights and click the PRE/PST button to set it as desired.
To make or break a connection in the OUTPUT ASSIGN pane, position the mouse
cursor over the desired connection node and drag upward or downward as desired.
Routing Busses to Internal Effect Using a Mouse
In the LOOP EFFECT ASSIGN pane, you can route any Aux bus or Direct bus to the
desired internal effect processor (Owner’s Manual Page 210). To do this, position the
mouse cursor over the desired bus’s node and drag upward or downward as desired.
To Next Page
Loading...
