Reference Manual
00809-0100-4841, Rev. AA
May 2007
Rosemount 3490 Series
www.rosemount.com
Section 3 Installation
Safety messages . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . page 3-1
Before You Install . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . page 3-2
Mounting the Rosemount 3490 Series Control Unit . . . . page 3-3
Electrical installation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . page 3-6
SAFETY MESSAGES Procedures and instructions in this section may require special precautions to
ensure the safety of the personnel performing the operations. Information that
raises potential safety issues is indicated by a warning symbol ( ). Please
refer to the following safety messages before performing an operation
preceded by this symbol.
Explosions could result in death or serious injury:
Verify that the operating environment is consistent with the appropriate locations
certifications (see Appendix B).
Do not remove the housing cover in explosive atmospheres when the circuit is alive.
Failure to follow safe installation and servicing guidelines could result in death or
serious injury:
Make sure only qualified personnel perform the installation.
Use the equipment only as specified in this manual. Failure to do so may impair the
protection provided by the equipment.
Do not perform any service other than those contained in this manual unless you are
qualified.
High voltage that may be present on leads could cause electrical shock:
Avoid contact with leads and terminals.
Make sure the main power to the Rosemount 3490 Series is off, and the lines to any
other external power source are disconnected or not powered while wiring.
To Next Page
Loading...