The built-in vertical Ecodry IN+ and drop ceiling ductable horizontal Ecodry CN+ dehumidifiers
are designed for civil, residential and small dimension commercial use, with high latent load that
require operation 24 h/day.
They are particularly suitable for buildings where room cooling happens by means of radiant
systems such as floor, walls, ceiling or columns.
Dehumidifiers Ecodry combine state-of-the-art technical solutions with pleasant aesthetic and,
thanks to the external covers (optional and only for wall versions), display installation is
foreseen.
Dehumidifiers Ecodry IN+ e CN+ (isothermal), if correctly fed with chilled water at 15°C, are
able to dehumidify room air without altering the temperature. This is possible thanks to the
presence of 2 heat exchangers that pre-cool the inlet air and post-cool it after dehumidification
process.
Dehumidifiers Ecodry IN+ DC e CN+ DC (hybrid), if correctly supplied with chilled water at
15°C, are able to dehumidify room air without altering the temperature and are also fitted with
room thermostat and brazed welded plate condenser, thus allowing the unit to provide cool air
when the room temperature exceeds the set-point set on the dehumidifier.
The low air speed does not create annoying air currents typical of the traditional air
conditioning systems, guaranteeing maximum room comfort.
The top-quality refrigeration, hydraulic, air and electrical components make Ecodry units state
of the art dehumidifiers in terms of efficiency, reliability and sound power emitted.
2.1 Structure
The unit is made of a white pre-varnished metal sheet structure; the internal structural
elements are made in electro-welded metal sheet, for efficient protection against corrosive
agents. All screws and fastening systems are made with non-oxidising materials, stainless steel
or carbon steel with surface passivation treatments. The unit panels are covered with an open-
cell polyurethane synthetic material for maximum sound absorption. This materials falls in class
1 in compliance with the UL 94 standard and is CFC-free.
The unit is completely closed and access is only frontally for vertical models or from below and
side for the horizontal models. Access to the compressor compartment is made easier by the
removable panel, which allows operating free from obstacles.
2.2 Identifying the unit
To Next Page
Loading...