Rossato Ecodry CN+ - Intended Use of Ecodry Units

Ecodry IN+ CN+ - Manual of installation, use and maintenance
the workplace must be suitably lit for the operations to carry out. Insufficient or excessive
lighting can entail risks;
wait about 10 minutes from the unit's switch off before performing maintenance in order to
avoid burns;
minimize the time of opening of the refrigerant circuit. Even reduced oil exposure to air
causes the absorption of large amounts of moisture from the same oil resulting in
formation of weak acids;
any work on the unit must be performed by qualified personnel;
before making any intervention or maintenance on the unit, make sure you have removed
the power supply;
check that the safety devices are working properly and do not have doubts about their
functioning; otherwise, do not start the unit under any circumstances;
only use equipment recommended by the manufacturer of the unit. To avoid personal
injury, do not use worn, damaged, poor quality or improvised equipment;
always keep the area where the unit is located clean and tidy. The smearing of oil and
grease and faulty equipment or parts is harmful to people because they can cause slips or
falls;
It is forbidden to use flammable fluids in cleanup operations.
To clean the unit, do not use gasoline, petroleum or solvents as the first leave an oily patina
that makes the depositing of dust easier, while the solvents (even weak) damage the paint and
then accelerate rusting. If a water jet penetrates into electrical equipment, apart from inducing
oxidation of the contacts, can also cause a malfunction of the unit. For this reason, do not use
jets of water or steam on sensors, connectors or any electrical part.
Particular attention must be paid to the state of integrity of pressurized tubes or other parts
subject to wear. You must also check that there is no leakage of fluids or other hazardous
substances.
If such situations occur, the operator is prohibited to restart the unit until the fault has been
repaired.
1.9 Intended use
The units Ecodry CN+ e IN+ units are dehumidifiers to be installed in combination with radiant
systems for air dehumidification, or cooling and dehumidification.
Their use is recommended within the operating limits listed in this manual.
DANGER:
do not repair high-pressure tubes with seals;
pressurised fluids in the refrigeration circuit and the presence of electrical components can cause
risky situations during installation and maintenance operations.

CAUTION:
once the cleaning of the unit has been carried out, the operator must verify that there are no
damaged or worn parts or not solidly fixed, otherwise request the intervention of a technician for
maintenance;

DANGER:
Place the unit in an environment where there is no danger of explosions, corrosion (near the sea)
or fires and where vibrations and electromagnetic fields are present. It is also forbidden to operate
differently than as recommended or neglecting safety procedures.

Ecodry IN+CN+_20190801 Page  di  Rossato Group Srl7 43