Rossato Ecodry CN+ - Electrical Circuits Overview; Electrical Equipment Standards

Ecodry IN+ CN+ - Manual of installation, use and maintenance
4. Electrical circuits
4.1 Electrical equipments
The electric panel is made and wired in accordance with the standards quoted in the
declaration of conformity.
The control circuit is protected by a fuse.
All remote commands are built with very low voltage signals, powered by an isolation
transformer.
CAUTION:
To stop the unit, do not disconnect the power from the upstream protection of the unit; this element
must be used to dissect the entire unit for maintenance. To switch off the unit, act on the user
terminal.

Ecodry IN+CN+_20190801 Page  di  Rossato Group Srl16 43