Operation
20 AC-x32 Series Installation and Programming Manual
4.3.3 Changing from Normal to Bypass Mode
By default, there is no Normal/Bypass code. The Normal/Bypass code
must first be programmed to use this function (see Section 5.6 to
create/modify the Normal/Bypass Code).
To change from Normal to Bypass mode:
1. Enter the 4-digit Normal/Bypass Code.
The Mode LED flashes orange.
2. Press # to confirm the mode change.
The Mode LED turns orange.
4.3.4 Changing from Bypass Mode to Normal Mode
By default, there is no Normal/Bypass code. The Normal/Bypass code
must first be programmed to use this function (see Section 5.6 to
create/modify the Normal/Bypass Code).
To change from Bypass to Normal mode:
1. Enter the 4-digit Normal/Bypass code.
The Mode LED flashes green.
2. Press # to confirm the mode change.
The Mode LED turns orange.
4.4 REX Button
The REX button is used to open the door without the use of a PIN
code, and must be located inside the premises to be secured. It is
usually located in a convenient location, such as inside the door or at
a receptionist's desk. The function of the REX button depends on
whether the Lock Strike Relay is programmed for Fail Safe Operation
To Next Page
Loading...
Need help?
General
