Rosslare AC Series User Manual

Programming
AC-x32 Series Installation and Programming Manual 35
4. Enter the 4-digit PIN
code of the Primary
Code belonging to the user you want to
delete.
The Mode LED flashes red.
5. Enter your Programming code to confirm the deletion.
If the Programming code is valid, three beeps are emitted and the
unit returns to Normal mode.
If the Programming code is invalid, a long beep is emitted and the
unit returns to Normal mode.
5.11 Return to Factory Default Settings
Be very careful before using this command as it erases the
entire memory, including all User and Special codes, and
returns all codes to their factory default settings.
To return to factory default settings:
1. Enter Programming mode.
2. Press 0 to enter Menu 0.
The Mode LED and the Door LED flash
red.
3. Enter your 4-digit Programming code.

If the Programming Code is valid, all memory is erased, three
beeps are emitted, and the controller returns to Normal
mode.
 If the Programming code is invalid, a long beep is emitted,
and the controller returns to Normal mode without erasing
the memory of the controller.
Mode
Door
Red
Orange
Mode
Door
Green
Mode
Door
Red
Red

Rosslare AC Series Specifications

General

Operating Voltage	12VDC
Input Voltage	12VDC
Communication	RS-485, TCP/IP
Output Voltage	12V DC
Enclosure Rating	IP65
Type	Access Control Unit