Programming
AC-x32 Series Installation and Programming Manual 23
5. Programming
Programming is done solely via the unit's keypad driven Programming
Menu System. To reach the Programming Menu System, the unit
must first be put into Programming mode (see Section 5.1).
During the manufacturing process, certain codes and settings are pre-
programmed. These settings are called the default factory settings.
Table 1 shows the names of all the unit’s menus. It also shows all the
default factory codes and settings.
Table 1: Programming Menu
Menu
Number
Menu Description Factory
Settings
1 Change Open Code 1 2580
2 Change Open Code 2 0852
3 Change Program Code 1234
4 Change Normal/Secure Code 3838
5 Change Normal/Bypass Code N/A
6 Change Door Release Time 0004
7 Enroll PIN code, proximity cards, or both N/A
8 Delete PIN code or proximity cards N/A
0 Return to default factory setting N/A
A complete description and instructions for each of the above menu
items is detailed in the following subsections.
To Next Page
Loading...
Need help?
General
