19
7.3 PLU Preset Parameter
7.3.1 PLU Attribute Preset
(Bar code input)
[PLU][subttl](Linked Dept No.) [subttl] (Price)[subttl]
(Descriptor)[subttl]
(
STC SEL AB
) [
subttl
]
(Input Stock)[subttl]
scan PLU（preset
next PLU）
Note:
At this time, you can continue preset next PLU, or press [TOTAL] key for quit. After
preset all the PLUs parameter you can press [check] Key for printing them.
(Bar Code Input)
[PLU]:
This step only used for entering the barcode manually. If input by scanner, scans the
barcode directly.
When ECR at the idle
status in the “Prog” mode, user wants to program a PLU record,
if the PLU barcode already existing in ECR system, just using the scanner scans the
barcode, then can go to this PLU.
(
STC SEL AB
) [
subttl
]
(Input Stock)[subttl]:
There is no this parameter in the default preset, but via the Bit A of terminal
status3 in the System Option Preset user can set PLU Stock options. Here we set
it to “1”.
If user did not set it, then has no this step operation. And if not set the FLAG A is 0
(this PLU stock function is inactive), also can’t input PLU stock.
(Bar Code): We can input by keyboard or by scanner.
(Linked DEPT No.): (1-16)
If a PLU linked with one department, the PLU will inherit the department’s attribute. Such as the
TAX/VAT Rate, Status.
(Price): Max. 6 digits. (1-999999)
(Descriptor): Max. 12 characters. See 6.2. Descriptors Inputting section for the
detail info.
STC SEL AB:
A：The stock function of this PLU is actives or not.
0: stock function is inactive
1: stock function is active
B：PLU stock
0: The new-preset amounts of PLU stock will overlay the original stock
1: The original amount of PLU stock will plus new-preset amount
2: The original amount of PLU stock will subtract the new –preset amount
To Next Page
