Royal 220DX - Welcome Message Preset; Trailer Message Preset; Clerk Programming

29
7.6 Welcome Message Preset
The Welcome Message can only be set with maximum 6 lines. Each line has maximum
characters as follows:
Normal 32 characters
Double Width 16 characters
Double Height 32 characters
Double width and height. 16 characters
（A） [qty/time] （TEXT INPUT） [subttl]
[TOTAL]/[
check
]
[TOTAL]
Without changing and
quit presetting
A ： Line Code 21-26 (1st line to 6th line)
See 6.2. Descriptors inputting section for the detail information
7.7 Trailer Message Preset
（A）[qty/time]（TEXT INPUT）[subttl][TOTAL]/[check]
A ： Line Code 31-36 (1st line to 6th line)
For detail operation please refer to Welcome Message Preset※
7.8 Clerk Programming
（A）[ qty/time] （PASS CODE）[subttl] (DESCRIPTOR) [subttl] [TOTAL]/[check]
A: Clerk Code, a maximum of 10 clerks can be preset.
41-50 (Clerk 1 to Clerk 10)
Pass Code: 4 digits
Descriptor: Max .12 characters. 6.2. Descriptors Inputting section for the detail
information
Note: 1.The pass code can’t be zero.
2.It doesn’t allow two same passcode.
3.Preset Clerk must be sure that the clerk function is activated.
Repeat if needed
Skip next line
Repeat if needed